If the faucet leaks at the outlet (at the aerator where the water normally comes out), you should replace the internal parts.
If the faucet leaks at the neck and faucet body, it is sufficient to replace the rubbers.
See here the Venus kitchen faucet parts
Venus parts drawingBelow we explain through photos how this faucet can be serviced again.
To start, always turn off the main faucet or if you have angle stop valves or filter stop faucets in the cabinet, you can also turn these off.
- Hold the faucet with one hand and pull the lever with the other hand, pull slightly upward at an angle. Sometimes it happens that the knob is quite calcified, then make a pulling and small twisting motion.
- Pull with pliers or carefully try with a flat thin screwdriver to remove the color marking (blue or red) plastic part 2306500 upward from the internal mechanism.
- Take a 17 socket/ring wrench or a pipe wrench and place it on the internal mechanism. Turn counterclockwise to unscrew the internal mechanism.
- Remove the internal mechanism from the faucet, check carefully that no rubber has been left behind in the faucet and that there is no more limescale in it. After that, install the internal mechanism, grease the rubber with the supplied faucet grease. Right side cold has grooves in the internal mechanism where the key is placed. 1329700Left side warm, here there are no grooves in the internal mechanism where the key is placed. 1329800
Here you can order a set for left and right 2392400
