You are currently not logged in.
There are no products in your shopping cart yet.
Looking for a Kesseböhmer gas strut? Kesseböhmer is a brand that develops a wide range of furniture and kitchen hardware. If a gas strut in your kitchen system has broken, chances are it's a Kesseböhmer gas strut. Many lift-up cabinets use Kesseböhmer Lift-o-Mat gas struts: gas pistons that hold the cabinet door up once it's open. We offer a wide range of Kesseböhmer gas struts for virtually every type and Newton rating. Below you'll find out which version fits your cabinet, how to remove the gas strut, and what to look out for when ordering a replacement.
There are two types of Kesseböhmer gas struts available, and you need to check which connection is fitted on each end of the strut. The most common gas strut system from this brand has a ball joint on both ends. To remove the gas strut from the system, insert a flathead screwdriver behind the retaining clip and pry it upward. Once that's done, you can easily detach the broken gas strut. Every Kesseböhmer gas strut has a type number stamped on it, along with a figure followed by an N (for Newton). This indicates the strength of the gas strut. Order your Kesseböhmer gas strut easily online with us and enjoy fast delivery and free shipping on orders over €99!
Also check out: Gas strut parts
If the piston in your gas strut has failed, it's time for a replacement. When fitting the new gas strut, make sure the piston rod (the thin rod part of the strut) points downward when the cabinet door is closed. This keeps the seal inside the gas strut properly lubricated, helping it last as long as possible. With correct use, a Kesseböhmer gas strut typically lasts around 7 years.
When ordering, pay close attention to the Newton rating of your current Kesseböhmer gas strut. The higher the pressure, the stronger the gas strut. That doesn't mean that if your current 200N strut has failed, you should just buy a 380N one to stop the door from sagging. Doing so will make the door shoot upward forcefully and become very hard to push back down. Our advice: stick with the same Newton rating as before. That way, the new gas strut will last just as long as the previous one.
The most common gas strut has a center-to-center length of 19.5 cm. This means that when fully extended, the centers of both ball joints are 19.5 cm apart. Measured from end to end, this comes to 21 cm. When a gas strut fails, you'll notice the cabinet door sinking down slowly, or sometimes suddenly. There's often also oil visible on the piston rod. That's your sign to order a new Kesseböhmer gas strut.
Not sure which Kesseböhmer gas strut you need? Always check the type number and Newton rating stamped on your current gas strut first. If you can no longer read this or don't have the number, measure the center-to-center length instead and check the type of fitting on both ends. This way you'll order the correct replacement in one go and avoid an incorrect fit.
Check your current gas strut for the type number and the figure followed by an N, which stands for the strength in Newton. If you no longer have this information, measure the center-to-center length and check the type of fitting on both ends. This way you'll always order the correct replacement for your cabinet.
Insert a flathead screwdriver behind the retaining clip at the end of the gas strut and carefully pry it upward. Once the clip is loose, you can simply pull the broken gas strut off the ball joint. Work slowly so you don't damage or lose the retaining clip.
No, always choose the same Newton rating as the original gas strut. A gas strut that's too strong will cause the door to shoot up forcefully and become difficult to push down. Sticking with the same pressure keeps the cabinet working just as smoothly as before.
With correct use and installation, a Kesseböhmer gas strut typically lasts around 7 years. Make sure the piston rod points downward once installed and the door is closed, as this keeps the internal seal properly lubricated and extends the gas strut's lifespan.
The most common Kesseböhmer gas strut has a center-to-center length of 19.5 cm between the ball joints, and 21 cm measured end to end. If you're unsure about the size, measure your current gas strut before ordering a new one so it fits perfectly.
Oil on the piston rod usually means the internal seal of the gas strut is worn and it's due for replacement. You'll often also notice the door sinking down slowly, or sometimes suddenly. In that case, order a new gas strut with the same specifications.
Product added to your quotation. Go to the quote page to complete your quotation request, we will contact you as soon as possible.
